Contact Us
TEL: +86 15205890219
Fax: +86-579-85432190
Address: Area B, Bld. 1-3, No.E21, Xinke Road, Yiwu, Zhejiang, China
Home > News > Content
The Use Process Of Laser Marking Machine
Nov 13, 2017

Check the waterway, the circuit is correct to boot. The boot sequence is:

① Plug in the line power and turn on the key switch. At this time, the machine ventilation and refrigeration system power, ammeter display value of about 7A;

② Wait 5-10 seconds, press the external Control Panel trigger button, ammeter display value of zero, 3-5 seconds after the Krypton lamp lit, ammeter display value 7 A. (Reference to the laser Power operation manual);

③ Open galvanometer power supply;

④ Turn on the computer, pull up the required marking file;

⑤ Adjusts the laser power supply to the working current (10~18a), can start marking;

After the marking is finished, reverse the power supply of each component in the following order:

① The laser power supply working current to the minimum (7A or so);

② Shuts down the computer;

③ Closed galvanometer power supply;

④ Press stop button;

⑤ Close key switch;

⑥ Disconnect power to the wire.