Contact Us
TEL: +86 15205890219
Fax: +86-579-85432190
E-mail: sales07@holylaser.com
Address: Area B, Bld. 1-3, No.E21, Xinke Road, Yiwu, Zhejiang, China
Home > News > Content
Considerations For Using Laser Engraving Machines
Nov 13, 2017

1. When using automatic focal length, note that the automatic measuring rod must be fastened, otherwise the worktable will be top to the laser.

2. Laser engraving machine at work, prohibit the boot lid.

3. Open smoke and smoke equipment when processing.

4. Processing wood, paper, must pay attention to processing speed in order to avoid fire.

5. The initial use of irregular processing when the red light positioning.

6. Processing of thin wood, volatile materials, to adjust the change of water products small 1mm.

7. In the cutting process, to use the workpiece rack from the table more than 2 centimeters.

8. Cleaning of reflective lenses and focal length lenses: Two fingers pinch reflective lenses. The other hand holds the camera lens clean the paper clean the lens.

9. Usually engraving vector file, the resolution should be high, engraving point of the file, the resolution should be lower.