Contact Us
TEL: +86 15205890219
Fax: +86-579-85432190
Address: Area B, Bld. 1-3, No.E21, Xinke Road, Yiwu, Zhejiang, China
Home > Knowledge > Content
Operation details of laser cutting machine
Nov 13, 2017

Laser cutting machine at work, if the failure is very dangerous, the novice must undergo professional training to operate independently, the following is the laser cutting machine security work 13 details:

1. Comply with general cutting machine safety procedures. Start the laser in strict accordance with the Laser Launcher program.

2. Operators must be trained, familiar with the equipment structure, performance, knowledge of the operating system.

3. In accordance with the provisions of the wearing of good labor protection supplies, in the vicinity of the laser beam must wear the protective glasses.

4. Do not process a material before it is clear whether it can be irradiated or heated by lasers to avoid the potential danger of smog and steam.

5. When the equipment starts, the operator shall not leave the post or the trustee to wait for the tube, if the need to leave should stop or cut off the power switch.

6. Put the fire extinguisher where it is readily available, turn off the laser or light brakes when not in process, and do not place paper, cloth or other flammable materials near unprotected laser beams.

7. In the process of detection of anomalies, should be immediately shut down, timely troubleshooting or report to the competent personnel.

8. Keep the laser, bed and surrounding site neat, orderly, no oil, workpiece, plate, scrap according to the provisions stacked.

9. The use of cylinders, should avoid the pressure of bad welding wire, so as to avoid leakage accident. The use and transportation of cylinders shall comply with the regulations of gas cylinders. No cylinders are allowed to explode or close to heat in the sun. When opening the bottle valve, the operator must stand on the side of the bottle mouth.

10. Follow high voltage safety regulations when repairing. Every 40 hours or weekly maintenance, 1000 hours per operation or six months of maintenance, according to the rules and procedures.

11. After the boot should be manual low-speed x, y direction to start the machine, check to confirm that there is no abnormal situation.

12. After entering the new workpiece program, try running it first and check its operation.

13. Work, pay attention to observe the operation of the machine, lest the cutting machine out of the effective range of travel or two crashes caused by the accident.

Previous: Main features of 3D printer

Next: Principle of laser Cutting machine